Exo Terra Lamp Holder Bracket for Reptiles

• Holds and suspends most light fixtures securely and is easily adjustable
• Extends life span of light bulbs due to not having to be moved after installation
• Moving the rubber washers allows you to regulate heat & light according to required terrarium conditions
• Helps prevent accidental flipping, and terrarium damage
• Light dome and wire light

The Exo Terra Lamp Holder Bracket for Reptiles was made to securely suspend a light source above a glass terrarium. This sturdy bracket easily adjusts to fit most types of fixtures. You can also regulate the heat and light based on your terrarium’s requirements by moving the rubber washers. The Exo Terra Lamp Holder Bracket extends the life span of a light bulb and helps prevent terrarium damage and accidental tipping.

Specifications

• Clean the outside surface of the terrarium glass.

• With the Protective Backing still intact, place the Light Bracket Support on the back or the side of the terrarium to determine its final position.

• Mark the position with a wax pencil or other marker.

• Remove the Protective Backing and carefully fit the Light Bracket Support within the marked area.

• Once in place, the Light Bracket should not be removed.

• Adjust the height and tighten the screw of the Light Bracket when the fixture is suspended above the terrarium at the desired height.

• Remove the first Rubber Washer and slide the Ring of the fixture’s support over the rod of the Light Bracket.

• Adjust the position of the fixtures by moving the remaining Rubber Washer.

• Replace the first Rubber Stopper to secure the Ring of the fixture’s support tightly in between both Rubber Stoppers.

• Ensure that the light’s focal point is not positioned above any plastic parts of the terrarium or screen cover to prevent damage.